john's 74 s&h clone build thread

... spent a few minutes making this panel, and painted and cleared it! paint will be cured by tomorrow, so you guys will have to tune in then to see where it goes 

TV 2M8O wrote: Goes above the firewall bulkhead connectors between fender and brake booster?

That is my guess too.

John,How are you gonna address the harness mounting holes along the firewall and fenders?

hmmm, i'm thinking!

no more ugly bulk head connectors   

painted the left caliper finally:
 

LOL, no seriously.... how are you going to finish off all those holes?

californiajohnny wrote:

...head light wiring is DONE!  just got to tie up some loose ends (i mean loose wires ) relays mounted: 
new wig wag flasher installed and working :
head light wiring all tucked up inside the core support:

...now for the drivers side:
 
...after about a half hour of adjusting the quarter window and the door window, i think i can live with the fit on this side now too! 
 


Edited by californiajohnny - 26-November-2014 at 9:58PM

Looking good there John....

i put on my left side rocker molding so far today:

and the rear:

got most of the extra dash wiring finished this morning, went outside to go into the other garage to get some more wire, and saw this!:

thanks chris! yeah it was just a flurry, they said it would snow today only, it's sunny now and gone

here it is mounted in the console (quick mock up installation) made a trip to the parts store for the toggle switch and a cig lighter outlet, then later while looking in my toolbox, i found 3 complete cig lighter outlets  

... and i finished most of the interior wiring, just have the stereo wiring to do then ALL of the wiring is FINISHED! i'm so tired of that damn seat belt bracket stuck up my a$$, plus laying on the floor with seat mounting studs jammed in my back


Edited by californiajohnny - 29-November-2014 at 7:17PM

John, I'm with you on the seatbelt bracket!!! been adding extra wiring through my bulkhead connector along with an aux fuse box...I feel your pain.