nss switch harness |
Post Reply |
Author | |
tjbooker
Member Joined: 21-August-2005 Status: Offline Points: 76 |
Post Options
Thanks(0)
Posted: 08-June-2017 at 4:29PM |
I have converted my column shift to a floor shift , I have also installed an aod trans , and I have used a ron francis aod plug and got that wired up into the harness, but I have no idea where the grey six prong plug(only five contacts) goes to make this work. can any of yu tell me where exactly does this harness wire into? its driving me crazy. Is there some
extended harness needed? where does that plug go? I know there were some posts abut this previously. |
|
californiajohnny
Moderator Group Joined: 05-October-2013 Location: winlock, wa Status: Offline Points: 14606 |
Post Options
Thanks(0)
|
i too swapped in a AOD and converted to a floor shift from a column shift in my car, i used the factory AOD plug from the van it took the AOD out of but had to test and wire it to my original column NSS connector.
the column shift NSS plug is near the brake pedal, i just drilled a hole at the bottom of the drivers floor pan added a grommet in the hole to protect the wires and just hard wired it to the appropriate circuits IIRC two wires are for the NSS and two are for the backup lights in that connector... |
|
JOHN
74 GRAN TORINO S&H CLONE 74 VETTE CUSTOM 90 S10 BLAZER 4X4 LIFTED 77 CELICA CUSTOM 75 V8 MONZA SUPERCHARGED 79 COURIER VERT. SLAMMED 75 VEGA V6 5 SPD 70 CHEV C10 P/U 68 MUSTANG FB CONVERSION |
|
tjbooker
Member Joined: 21-August-2005 Status: Offline Points: 76 |
Post Options
Thanks(0)
|
I have it all wired into the harness but I don't know where to plug the ford original harness with the grey plug end into. it should be plug and play somewhere. I don't have toe column shift in there I took the floor shift column and put that in/ so basically ive wired everything to the harness where does the floor plug go?
|
|
tjbooker
Member Joined: 21-August-2005 Status: Offline Points: 76 |
Post Options
Thanks(0)
|
you say near the brake pedal?
|
|
californiajohnny
Moderator Group Joined: 05-October-2013 Location: winlock, wa Status: Offline Points: 14606 |
Post Options
Thanks(0)
|
yes the original column shift NSS connector is by the brake pedal up above the steering column shaft it's square should be hanging somewhere in that area
|
|
JOHN
74 GRAN TORINO S&H CLONE 74 VETTE CUSTOM 90 S10 BLAZER 4X4 LIFTED 77 CELICA CUSTOM 75 V8 MONZA SUPERCHARGED 79 COURIER VERT. SLAMMED 75 VEGA V6 5 SPD 70 CHEV C10 P/U 68 MUSTANG FB CONVERSION |
|
tjbooker
Member Joined: 21-August-2005 Status: Offline Points: 76 |
Post Options
Thanks(0)
|
I will look there thank you!
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |