The Ford Torino Page Homepage
Forum Home Forum Home > Model Specific Forum > General Automotive Technical Discussion
  New Posts New Posts RSS Feed - Pedal bearing installation
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Pedal bearing installation

 Post Reply Post Reply
Author
Message
armymn1984 View Drop Down
New Member
New Member
Avatar

Joined: 25-January-2016
Location: Florida
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote armymn1984 Quote  Post ReplyReply Direct Link To This Post Topic: Pedal bearing installation
    Posted: 31-October-2017 at 4:58AM
so I recently put a bearing kit in for the pedals. What I did was cut the bushing off as close as I could to the pedal bracket. I then used a ball peen hammer and knocked the inside portion out. I retained the inside portion as i used it to align the bearing and housing. I put the shaft through to keep both the inner bushing and bearing centered while I tacked the bearing housing down. Repeat the same process for the other side. I Used TIG to weld it in but shouldn't be too hard to use MIG. Keep in mind it's a thin metal and overheating it will tend to warp the metal so take your time. I picked up the bearing kit from mustang steves online. It also comes with instructions on how to do it.
Airborne All the way!!!
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

This page was generated in 0.094 seconds.