The Ford Torino Page Homepage
Forum Home Forum Home > Model Specific Forum > 1972-1976 Ford and Mercury
  New Posts New Posts RSS Feed - regulator rollers
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

regulator rollers

 Post Reply Post Reply
Author
Message
1973gts View Drop Down
Senior Member
Senior Member
Avatar

Joined: 05-March-2018
Location: Grand Rapids Mi
Status: Offline
Points: 608
Post Options Post Options   Thanks (0) Thanks(0)   Quote 1973gts Quote  Post ReplyReply Direct Link To This Post Topic: regulator rollers
    Posted: 26-February-2020 at 2:16AM
I have searched the forum but have not located a definite answer on this topic.  I need to replace my regulator rollers and know the ones for the front windows (Dorman 74402) but could not find if these work for the rear quarter windows. Will these work for the rear or do I need different ones and if so which ones?  
Dave - 1973 GTS N code
Back to Top
californiajohnny View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 05-October-2013
Location: winlock, wa
Status: Offline
Points: 14606
Post Options Post Options   Thanks (0) Thanks(0)   Quote californiajohnny Quote  Post ReplyReply Direct Link To This Post Posted: 26-February-2020 at 1:55PM
far as i know they are the same? measure a front one and a rear one to compareWink
JOHN
74 GRAN TORINO S&H CLONE
74 VETTE CUSTOM
90 S10 BLAZER 4X4 LIFTED
77 CELICA CUSTOM
75 V8 MONZA SUPERCHARGED
79 COURIER VERT. SLAMMED
75 VEGA V6 5 SPD
70 CHEV C10 P/U
68 MUSTANG FB CONVERSION
Back to Top
1973gts View Drop Down
Senior Member
Senior Member
Avatar

Joined: 05-March-2018
Location: Grand Rapids Mi
Status: Offline
Points: 608
Post Options Post Options   Thanks (0) Thanks(0)   Quote 1973gts Quote  Post ReplyReply Direct Link To This Post Posted: 26-February-2020 at 4:17PM
John, the problem I have is that both my rear rollers were gone when I took the regulators out.  I think I will just check and see if the new rollers fit in the guide, if so should be good.  
Dave - 1973 GTS N code
Back to Top
californiajohnny View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 05-October-2013
Location: winlock, wa
Status: Offline
Points: 14606
Post Options Post Options   Thanks (0) Thanks(0)   Quote californiajohnny Quote  Post ReplyReply Direct Link To This Post Posted: 26-February-2020 at 6:49PM
yes that will work Wink btw the square replacement ones are fine they don't need to be round like the factory ones were! they just slide in the track and rotate at the pivot stud Big smile actually a better design now!!!
JOHN
74 GRAN TORINO S&H CLONE
74 VETTE CUSTOM
90 S10 BLAZER 4X4 LIFTED
77 CELICA CUSTOM
75 V8 MONZA SUPERCHARGED
79 COURIER VERT. SLAMMED
75 VEGA V6 5 SPD
70 CHEV C10 P/U
68 MUSTANG FB CONVERSION
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

This page was generated in 0.125 seconds.