interchange help |
Post Reply |
Author | |
69fastford
New Member Joined: 16-March-2006 Location: United States Status: Offline Points: 9 |
Post Options
Thanks(0)
Posted: 25-October-2007 at 12:51PM |
i have a 1970 mustang with disk brakes and a 9 inch rear.will any of this stuff work on my 69 fairlane? any help would be appreciated. thanks mark
|
|
erics69cobra
New Member Joined: 11-December-2007 Location: United States Status: Offline Points: 1 |
Post Options
Thanks(0)
|
Hi Mark, I don't know if you found any help yet but many parts will interchange. If you still need help with this email me with what parts you want to know if they will work my email address is ericd4027@yahoo.com
ERIC
|
|
stuck
Senior Member Joined: 23-December-2007 Location: michigan Status: Offline Points: 279 |
Post Options
Thanks(0)
|
check your tie rods compare the size of the nut the 70 mustang had larger tie rod/hole in spindle.if you can swap nuts you can swap spindles presto disc brakes.for the 9 compare ujoint size or drive shaft lengths , measure guide pin hole center of u bolts.on your back looking up.if you need help holding measuring device remember theres a dumb guy end and smart guy end.can i have your leftovers.
Edited by big8big472 - 23-December-2007 at 4:29PM |
|
michigan
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |