400 build up and flexplate question |
Post Reply | Page <12 |
Author | |||
The Torino Kid
Senior Member Joined: 23-November-2003 Location: United States Status: Offline Points: 250 |
Post Options
Thanks(0)
|
||
So I would like all of all your opinions on another matter. I bought the 400 off of a private party. It's 80% built, crank,cam,lifters,rocker arms,push-rods,water pump,timing chain,intake on(which I will use my own intake) heads on(which I am also changing) I want to go over all the side clearances for the crankshaft,rods and make sure the rear main seal is properly installed, it was sitting for awhile before i purchased it. Should I remove the bearing caps and re-lubricate the main bearings?
|
|||
1973 Gran Torino Sport CJ 351
'Q' code 63R body |
|||
Rockatansky
Senior Member Joined: 30-July-2010 Location: On The Road Status: Offline Points: 6072 |
Post Options
Thanks(0)
|
||
let us know what you get
|
|||
72 GT Ute
|
|||
The Torino Kid
Senior Member Joined: 23-November-2003 Location: United States Status: Offline Points: 250 |
Post Options
Thanks(0)
|
||
I got the pioneer one from summit, it looks like a stock replacement unit...nothing like the one in the picture used though. but it was on sale for 99.50 so it qualified for free shipping.
|
|||
1973 Gran Torino Sport CJ 351
'Q' code 63R body |
|||
Post Reply | Page <12 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |