Engine crank/torque converter question |
Post Reply |
Author | |
Rivercrest
Member Joined: 07-December-2019 Location: Manitoba Canada Status: Offline Points: 175 |
Post Options
Thanks(0)
Posted: 04-June-2020 at 12:52PM |
All is good
Edited by Rivercrest - 07-June-2020 at 3:07AM |
|
Rockatansky
Senior Member Joined: 30-July-2010 Location: On The Road Status: Offline Points: 6059 |
Post Options
Thanks(0)
|
72 GT Ute
|
|
handsofstone
Senior Member Joined: 13-April-2018 Location: Northeast Status: Offline Points: 3941 |
Post Options
Thanks(0)
|
Fill it with grease and use a round pin that is a tight fit. hit it with a hammer and after a few refills of grease, it will pop right out.
|
|
californiajohnny
Moderator Group Joined: 05-October-2013 Location: winlock, wa Status: Offline Points: 14606 |
Post Options
Thanks(0)
|
it's a pilot bushing for a manual trans, remove it for a torque convertor
|
|
JOHN
74 GRAN TORINO S&H CLONE 74 VETTE CUSTOM 90 S10 BLAZER 4X4 LIFTED 77 CELICA CUSTOM 75 V8 MONZA SUPERCHARGED 79 COURIER VERT. SLAMMED 75 VEGA V6 5 SPD 70 CHEV C10 P/U 68 MUSTANG FB CONVERSION |
|
Rivercrest
Member Joined: 07-December-2019 Location: Manitoba Canada Status: Offline Points: 175 |
Post Options
Thanks(0)
|
Job is done.........thanks
|
|
handsofstone
Senior Member Joined: 13-April-2018 Location: Northeast Status: Offline Points: 3941 |
Post Options
Thanks(0)
|
Did you get the tool? I think the builder was subtly telling you to get a manual transmission. Haha
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |