![]() |
1972 Ranchero - air plenum side weather seal |
Post Reply ![]() |
Author | |
aussie_dave ![]() Member ![]() Joined: 17-March-2015 Location: Vic Australia Status: Offline Points: 65 |
![]() ![]() ![]() ![]() ![]() Posted: 28-May-2015 at 11:35PM |
Its time for a bit of work on the outside, now that l have most of the inside in place, the guards/fenders ... have a weather seal hidden within them for the air plenum just below the windshield, there are two, one on each side, does anyone know where they are sold, l have scoured everywhere for two of them!!! Thanks in advance David
![]() |
|
David Dare
|
|
![]() |
|
Regul8r ![]() Admin Group ![]() ![]() Moderator Joined: 26-December-2007 Location: Sarasota FL Status: Offline Points: 6623 |
![]() ![]() ![]() ![]() ![]() |
Dave are you asking about the plastic grate/covers that go over the holes where you get inside the cowl to access the Windshield Wiper stuff?
IF so, I can grab a couple of them tomorrow while I am at the farm. Pay the shipping and couple bucks and they are yours. |
|
Carl Corey (Moderator/Event Coordinator) Contact ANYTIME!
1976 Ford Elite "Lola Mae" 97 Suzuki Intruder 1400 US Army Retired |
|
![]() |
|
starsky460 ![]() Senior Member ![]() Joined: 01-April-2010 Location: Ply Meeting PA Status: Offline Points: 209 |
![]() ![]() ![]() ![]() ![]() |
Edited by starsky460 - 29-May-2015 at 3:44AM |
|
Carl
1976 Gran Torino Starsky & Hutch Limited Edition FACTORY 460 c.u. engine 3:55 gears |
|
![]() |
|
mcford ![]() Senior Member ![]() ![]() Joined: 31-May-2003 Location: Utica, Michigan Status: Offline Points: 2160 |
![]() ![]() ![]() ![]() ![]() |
I'VE GOT A STACK OF THEM.
|
|
Mike
|
|
![]() |
|
aussie_dave ![]() Member ![]() Joined: 17-March-2015 Location: Vic Australia Status: Offline Points: 65 |
![]() ![]() ![]() ![]() ![]() |
Ah no they are at the very sides of the plenum. Small openings to allow any water to run out down between the inside of the fender and the firewall. I have those top grates, thank you for the offer.
The seal or rubber flap has a metal holder over the top section to hold it in place and 3 small phillips head screws to hold that in place. It would only be about 3 inches long and 1 inch tall... the hole that this flap covers. Hopefully that clears up the desription and location. Davud. |
|
David Dare
|
|
![]() |
|
Regul8r ![]() Admin Group ![]() ![]() Moderator Joined: 26-December-2007 Location: Sarasota FL Status: Offline Points: 6623 |
![]() ![]() ![]() ![]() ![]() |
yup, I know what you are talking about now... nope don't have any.
In reality you don't need it if you don't daily drive in the rain. It is there to keep road spray around the wheel well skirts from going up into the cowl area and to keep critters out. then it lets the water flow out to drain. A piece of screen and a small flap of rubber and you can make something. |
|
Carl Corey (Moderator/Event Coordinator) Contact ANYTIME!
1976 Ford Elite "Lola Mae" 97 Suzuki Intruder 1400 US Army Retired |
|
![]() |
|
aussie_dave ![]() Member ![]() Joined: 17-March-2015 Location: Vic Australia Status: Offline Points: 65 |
![]() ![]() ![]() ![]() ![]() |
Yep thats what l thought too just make two.
Thanks for your reply. Cheers David. |
|
David Dare
|
|
![]() |
|
Big Bird ![]() Senior Member ![]() ![]() Joined: 25-August-2013 Location: New York Status: Offline Points: 4194 |
![]() ![]() ![]() ![]() ![]() |
Is this the flappy thing on the side of the cowl?
|
|
"What we do in full frontal view, is more honest than your cleaned-up mind."
Randy 1979 T-Bird 2005 F-150 STX RCSB 4.6, 3.55 LSD How the Heck does a REGULAR CAB SHORTBED weigh over 5200 pounds? |
|
![]() |
|
Regul8r ![]() Admin Group ![]() ![]() Moderator Joined: 26-December-2007 Location: Sarasota FL Status: Offline Points: 6623 |
![]() ![]() ![]() ![]() ![]() |
picture of the ROTTED what was left of the passenger side of the yellow one I stripped.
It had a metal hold down plate the rubber was formed to. |
|
Carl Corey (Moderator/Event Coordinator) Contact ANYTIME!
1976 Ford Elite "Lola Mae" 97 Suzuki Intruder 1400 US Army Retired |
|
![]() |
|
andrewok1 ![]() Senior Member ![]() ![]() Joined: 02-June-2015 Location: OCALA FL Status: Offline Points: 423 |
![]() ![]() ![]() ![]() ![]() |
|
|
GET IT GOT IT GONE !!!!!!!
|
|
![]() |
|
andrewok1 ![]() Senior Member ![]() ![]() Joined: 02-June-2015 Location: OCALA FL Status: Offline Points: 423 |
![]() ![]() ![]() ![]() ![]() |
i have bought them for my projects ,on ebay
i used a rubber tire tube and i bent a piece of sheet metal and made the flap that way it also keeps the air from rushing up your dash vents
|
|
GET IT GOT IT GONE !!!!!!!
|
|
![]() |
Post Reply ![]() |
|
Tweet |
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |