The Ford Torino Page Homepage
Forum Home Forum Home > General Discussion > Auto Body Forum
  New Posts New Posts RSS Feed - CLEANING LARGE PARTS
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

CLEANING LARGE PARTS

 Post Reply Post Reply
Author
Message
castillo View Drop Down
Senior Member
Senior Member


Joined: 20-February-2007
Location: United States
Status: Offline
Points: 352
Post Options Post Options   Thanks (0) Thanks(0)   Quote castillo Quote  Post ReplyReply Direct Link To This Post Topic: CLEANING LARGE PARTS
    Posted: 21-March-2008 at 4:21PM

I would like everyones advise on cleaning items like hood,doors,inner fenders, fenders.. I currently get small parts hot tanked & beadblasted by my machinist.. I have not found  a parts cleaner, home chemical cleaner or home steamer which even matches his hot tank..My problem is his tank is limited to items no bigger than an engine block..Does any one have suggestions..Also if you need large parts sand or media blasted use a tombstone/headstone company.. They media blast reasonable size items very cheaply.. I've had fenders done for 20.00 each

Back to Top
starsky76 View Drop Down
Senior Member
Senior Member
Avatar

Joined: 28-March-2008
Location: vegas
Status: Offline
Points: 1385
Post Options Post Options   Thanks (0) Thanks(0)   Quote starsky76 Quote  Post ReplyReply Direct Link To This Post Posted: 28-March-2008 at 12:30PM
Your best to get large parts plastic media blasted if there is no rust.otherwise sand can be used on a low pressure setting.Also soda blasting is the latest craze,but not cheap.I had my whole car done,in plastic media and sand for the frame,came out mint!76 starsky annd hutch factory car,body off resto.
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

This page was generated in 0.125 seconds.