inside trunk lip
Printed From: The Ford Torino Page
Category: Model Specific Forum
Forum Name: 1972-1976 Ford and Mercury
Forum Description: Technical discussion for 1972-1976 Ford and Mercury
URL: https://forum.grantorinosport.org/forum_posts.asp?TID=3626
Printed Date: 26-March-2026 at 3:24PM
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com
Topic: inside trunk lip
Posted By: dspring107
Subject: inside trunk lip
Date Posted: 17-May-2010 at 10:09AM
| looking for a the lip that holds the rubber gasket in the trunk ,as my lower channel is rotted out on my 73 gts fastback. anybody have a decent one?let me know |
Replies:
Posted By: Eliteman76
Date Posted: 17-May-2010 at 2:28PM
|
Can you post a picture? What section? By the latch, or by the corners? -------------  Andrew:GTS.ORG admin, '72 Q code 5 speed RestomodPondering: #99Problems |
Posted By: dspring107
Date Posted: 17-May-2010 at 3:32PM
|
its the corners. there is a seam in the corner upper corner can be fixed lower corner was so bad i cut it out.it goes from the seam to about 8 inches toward the latch. |
Posted By: Guests
Date Posted: 17-May-2010 at 5:59PM
| you can have a channel bent at most any sheetmetal supply and fabrication co. then just weld it in cut a piece off where it's good for a sample for them to duplicate a length of |
Posted By: Eliteman76
Date Posted: 19-May-2010 at 7:38PM
|
I have the section for the center off a 72 gts trunk floor, but not up into the corners. I have one saved off an Elite, but the panel is different. ------------- Andrew:GTS.ORG admin, '72 Q code 5 speed RestomodPondering: #99Problems |