The Ford Torino Page Homepage
Forum Home Forum Home > Model Specific Forum > 1972-1976 Ford and Mercury
  New Posts New Posts RSS Feed - inside trunk lip
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

inside trunk lip
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
dspring107 View Drop Down
Member
Member


Joined: 06-December-2007
Location: chalmette,la.
Status: Offline
Points: 62 		Post Options Post Options   Thanks (0) Thanks(0)   Quote dspring107 Quote  Post ReplyReply Direct Link To This Post Topic: inside trunk lip
    Posted: 17-May-2010 at 10:09AM
looking for a the lip that holds the rubber gasket in the trunk ,as my lower channel is rotted out on my 73 gts fastback. anybody have a decent one?let me know
Back to Top
Eliteman76 View Drop Down
Admin Group
Admin Group


Joined: 20-March-2006
Location: Nebraska, USA
Status: Offline
Points: 5450 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Eliteman76 Quote  Post ReplyReply Direct Link To This Post Posted: 17-May-2010 at 2:28PM
Can you post a picture? What section? By the latch, or by the corners?
Andrew:GTS.ORG admin, '72 Q code 5 speed Restomod
Pondering: #99Problems
Back to Top
dspring107 View Drop Down
Member
Member


Joined: 06-December-2007
Location: chalmette,la.
Status: Offline
Points: 62 		Post Options Post Options   Thanks (0) Thanks(0)   Quote dspring107 Quote  Post ReplyReply Direct Link To This Post Posted: 17-May-2010 at 3:32PM
its the corners. there is a seam in the corner upper corner can be fixed lower corner was so bad i cut it out.it goes from the seam to about 8 inches toward the latch.
Back to Top
Guests View Drop Down
Guest
Guest
Post Options Post Options   Thanks (0) Thanks(0)   Quote Guests Quote  Post ReplyReply Direct Link To This Post Posted: 17-May-2010 at 5:59PM
you can have a channel bent at most any sheetmetal supply and fabrication co. then just weld it in cut a piece off where it's good for a sample for them to duplicate a length of
Back to Top
Eliteman76 View Drop Down
Admin Group
Admin Group


Joined: 20-March-2006
Location: Nebraska, USA
Status: Offline
Points: 5450 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Eliteman76 Quote  Post ReplyReply Direct Link To This Post Posted: 19-May-2010 at 7:38PM
I have the section for the center off a 72 gts trunk floor, but not up into the corners.
I have one saved off an Elite, but the panel is different.
Andrew:GTS.ORG admin, '72 Q code 5 speed Restomod
Pondering: #99Problems
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

This page was generated in 0.078 seconds.